When there is a deeper or intermittant issue.
When running from the canoscan toolbox I got the error "Cannot communicate with the scanner - check cable and connection."īUT, i had this little flinker working just fine, when I was doing it's install I specifically tested it, the last thing i was going to do was believe it :-) or believe some MS error, the troubleshooter was useless again, as it often is I have a 8400, what I get is similar and different. Didn't we go through this with the downloads?
Scangear tool doesn find scanner install#
Please install it from the Installation CD or manufacturer's website and try again.
Scangear tool doesn find scanner driver#
Onthe "Devices and Printers" panel, the CanoScan appears BUT when clicked on an Exclamation point message appears saying: ! You need a WIA driver to use this device. Where or what is the "Built-in Application"? B. " Lamp lights then after ~2 min error message as in 2 above appears. Initiated scan using "CanoScan" selected "Copy" (also used "File" for a second try) As before we get a pop-up Window saying "scanning in progress do not open lid. Downloaded the Canon Software from your suggested site - It is identical to that on the computer. Scanner driver will be closed." Under this message in a second window is another that says " TWAIN data transfer error." 3. Cable may be disconnected or Scanner turned off. The error message appears in a window with the title From ScanGuard CS "Cannot communicate with scanner. The error message alwaws comes after the scanner fails to initiate the scan. The Canon Scanning software has always been used. There are no marks of any kind next to any item in the device Manager after plugging in the Scanner.
0 kommentar(er)
